Follow these steps to configure your Logitech Mevo 2.0 App with sidelineHD .


Download Mevo 2.0 App



Setup Mevo 2.0 App


  1. Power up your Mevo device by pressing and holding the power button for three seconds. The white LED lights will pop on and then start blinking as it initializes.


  1. Navigate to your sidelineHD STREAMING tab on the device you will use to run your Mevo.


  1. Click the ADD CAMERA (if new) or EDIT CAMERA button and select Mevo.    




  1. Click NEXT and then the Logitech Mevo App button.



  1. Click the Pair with Mevo button.

NOTE:  If you're a first time user you will get many prompts for approval. Make sure you click yes, agree, install, download etc. when prompted.


  1. After a successful setup with the Logitech Mevo 2.0 App you'll see this screen. Click the blue LAUNCH MEVO APP button.




Livestream With Mevo 2.0 App

  1. Toggle to select either Wi-Fi or Cellular Data:

    1. If you have a stand alone Hotspot / MiFi, or plan to use a personal hotspot from a different cell phone, select Wi-Fi.

    2. To use your phone’s data plan, select Cellular Data.


  1. If you selected Wi-Fi: Click on STREAM VIA Wi-Fi.  You will be prompted to locate and click on your Wi-Fi network. Click JOIN on any pop up menus.



  1. If you selected Cellular Data: Click on STREAM VIA CELLULAR DATA. Click JOIN on any pop up menus.



  1. To go live, push the RED button on the bottom left hand corner.


  1. Follow these steps to go live (the steps are noted in the picture below):

  1. Select RTMP (Do not select Facebook or YouTube).

  2. Choose the sidelineHD logo.

  3. Set resolution to 720p or lower. 

  4. Press the GO LIVE button.

If everything is working correctly, you should receive an UP text message from sidelineHD within 30 seconds.


TIP: If you get repeated up/down messages, it's likely because your connection does not have enough bandwidth.  Downshift to 480p or 360p (#3 in the picture above) to save your livestream.